Spindle Clamp Force Tester Gauge BT30 BT40 BT50
Гарантия возврата денег, если товар не подойдёт
Описание
Spindle Clamp Force Tester GaugeSpindles require routine maintenance. We recommend checking your drawbar force frequently to avoid downtime and costly repairs that could have been prevented.Our Drawbar Force Gage allows you to easily check the drawbar pressure of your machine spindle. Also called a Drawbar Dynomometer. Comes in a hardshell Case. Note: Drawbar gage is not direct reading.(PSI reading on gage) X 1.6 = Drawbar force in LBS.MODEL MEASURING RANGEWEIGHT KGBT300~150kg/cm²4.2KGBT400~150kg/cm²4.3KGBT500~350kg/cm²6.7KGProduct Features:Hydraulic mechanical structure, high stabilitySpecifications Instructions:1. Verify pull force gauge bolt specifications on with four claw specifications correspond.2. Rally and the front spindle taper portion wipe clean,Rally to clamp.3. In response to the specifications of each knife, pull range as follows:4.Use the German WIKA oil pressure gaugea: Determine whether the internal preload is in a normal state before usingInspection methods:1. Pointer is not at zero, and there is left pre-pressure 2. Manually check the pressure gauge and the body will turnNot rotating means there is left pre-pressure. Otherwise, if it’s rotating, that means there is no pre-pressure.b: Clamping Force Gauge restore the preload method1. Remove the B plug.2. Loosen the A lever and loosen it again.3. Push the A lever inwards (so that the oil level is reduced).4. Then R68 hydraulic oil from the B hole to fill, after the first plug into the plug.5. Then tighten the A lever, then C gauge pointer will move up.When the A-rod fully tightened when the pressure is the most appropriate indication should be between 10kg ~ 30kg, if more than 30kg, then the B plug will be unbeatable internal oil micro-oozed to adjust the internal pressure until the pressure the index showed in the range of 10kg ~ 30kg.c: Clamping Force Gauge reading methodThe inner area of the tension meter 10.00875, so when the tension gauge pointer on the pressure data multiplied by 10, the correct tensionNewtons = 98 kg relative to the Newton units shown in the Electronic Rallymeter.The unit of pressure shown in this product is 1 kg = 10 kg tensiond: Clamping Force Gauge of the rod to replace the way1. Clamp the surface of the pressure gauge2. Turn the A lever (B plug can not move)3. Replace the new lever and lock4.Once again check the preload, preload normal can continue to useOur CompanyProduct Process
Свойства товара
- Place of Origin: HEBEI
- Model Number: BT30
- Product name: Spindle drawbar force gauge
- MOQ: 1PCS
- model: BT30 BT40 BT50