GSM-сигнализация, GSM-термометр BAZA-10, питание 12В, 2 шлейфа, 2 реле

Гарантия возврата денег, если товар не подойдёт

Описание GSM alarm "BAZA-10" description and user manual Description The GSM alarm "BAZA-10" is designed to protect stationary objects using any available sensors (motion sensors, reed switches, breakage device, etc.). The device contains a GSM module, with the help of which, when the sensors are triggered, the alarm system makes an alarm call and (or) sends an alarm SMS to the phone numbers stored in its memory. Two normally open relays (dry contacts) with a maximum current of up to 10 amperes are installed on the alarm board. 1 is switched on and off by SMS command and can be used as a switch to remotely turn on any load up to 2 kilowatts. Relay No. 2 turns on when the sensors are triggered for 60 seconds and can be used to turn on the siren or any other load. any adapter with a voltage of 7 to 28 volts and a current of at least 500 milliamps; • Temperature sensor DS18B20 is installed on the board. Measures temperature in the range -55°C to +125°C • Current consumption in security mode 6 milliamps (with relay No. 2 on - 50 milliamps); • Current consumption in sensor operation mode up to 350 milliamps; The number of independent sensors to be connected is 2;• Operating ambient temperature is from -30 to +50 and depends on the sensors used. Preparing the alarm for operation1. Unscrew the stand (nut) in the center of the alarm and remove the board from the housing.2. Insert the micro SIM card into the slot as shown in the photo. No PIN code must be set on the SIM card.3. Connect the alarm according to the diagram.4. 20 seconds after switching on, call the alarm SIM card number from the phone, which will receive alarm calls and SMS in the future. alarm, all other numbers not added from the main phone are ignored. Arming, disarming the alarm To arm or disarm the alarm, call the alarm SIM card number. The alarm will reset the incoming call and send an SMS with the text “Signal OFF. ” (armed off, green LED lights up), the next call to the alarm SIM card number will lead to its transfer to the “armed mode”, the red LED will light up and in response you will receive an SMS with the text “Signal ON.” etc. To arm or disarm the alarm, you can also use SMS commands: Signalon — to arm, Signaloff — to disarm. Setting the temperature limits of the alarm device To set the lower limit of the alarm temperature, send an SMS command Low:10 where: Low — command : — delimiter 10 — lower limit temperature 10 °C Command examples: Low:5 Low:-20To set the upper limit of the alarm temperature, send an SMS command High:35 Commands Low and High are similar in syntax. When exiting
Свойства товара
  • Тип связи: Сотовая GSM
  • Степень защиты: IP54
  • Особенности: Оповещение через SMS/MMS
  • Размеры, мм: 115x100x35
  • Количество в упаковке, шт: 1
  • Питание от: аккумулятора
  • Диапазон рабочих температур, °С: -30...+50
  • Тип: Комплект охранной системы для дома или дачи
  • Бренд: 42unita.ru
  • Цвет: Светло-серый

Комментарии

Популярные объявления