Фрезы по дереву по лучшей цене в украине!
Гарантия возврата денег, если товар не подойдёт
Свойства товара
- img: ['https://besplatka.ua/aws/746x-/46/52/90/29/derevoobrabatyvayushchie-frezy-po-luchshei-cene-v-ukraine-photo-8be6.JPG', 'https:/ /besplatka.ua/aws/746x-/46/52/90/29/derevoobrabatyvayushchie-frezy-po-luchshei-cene-v-ukraine-photo-1ac7.jpg', 'https://besplatka.ua/aws/ 746x-/46/52/90/29/derevoobrabatyvayushchie-frezy-po-luchshei-cene-v-ukraine-photo-37e7.jpg', 'https://besplatka.ua/aws/746x-/46/52/ 90/29/derevoobrabatyvayushchie-frezy-po-luchshei-cene-v-ukraine-photo-b4e9.jpg', 'https://besplatka.ua/aws/746x-/46/52/90/29/derevoobrabatyvayushchie-frezy -po-luchshei-cene-v-ukraine-photo-4ec9.jpg', 'https://besplatka.ua/aws/746x-/46/52/90/29/derevoobrabatyvayushchie-frezy-po-luchshei-cene- v-ukraine-photo-5772.jpg', 'https://besplatka.ua/aws/746x-/46/52/90/29/derevoobrabatyvayushchie-frezy-po-luchshei-cene-v-ukraine-photo-c258.jpg', 'https://besplatka.ua/aws/746x-/ 46/52/90/29/derevoobrabatyvayushchie-frezy-po-luchshei-cene-v-ukraine-photo-7a74.jpg']
- url: https://besplatka.ua/ru/obyavlenie/derevoobrabatyvayushchie-frezy-po-luchshei-cene-v-ukraine-4ad2ab
- City: Kyiv
- description: cons. According to the characteristics, the hard alloy is more preferable than VK15, but given the fact that it is not possible to visually distinguish the difference between them, it remains to rely only on the manufacturer, i.e. it does not matter which of them, the main thing is that the VC. Currently, hard alloy from the Middle Kingdom is often used, it is usually distinguished by a thickness of 6-10 mm (usually the thickness of domestic alloy plates is 3-4 mm, manufacturers are Kiev, Svetlovodsk, Vladikavkaz), the quality is not always bad, but causticity and very low maintainability are noted. In addition, domestic production culture. It is sharpened only with a diamond wheel on the front surface of the cutting plate. A good choice for the manufacture of products: doors, windows, handrails, etc., also has a high operating time before sharpening (up to 25,000 running meters) when processing molded products: lining, floor board, block house, architraves, etc., but here, as experience shows, there is a drawback, on knotty wood, teeth can go astray. In addition, it should be taken into account that sharpening a carbide tool requires qualifications and equipment, it is important when sharpening a cutter to remove evenly along the front surface of each tooth within 0.02 mm, the value depends on the state of the cutting element. website: http://cae.kiev.uaE_mail: alsan1@ukr.netVvozny Evgeny Nikolaevich