Домкрат пневмокатковый дп-2
Гарантия возврата денег, если товар не подойдёт
Свойства товара
- img: ['https://besplatka.ua/aws/746x-/99/05/36/77/domkrat-pnevmaticheskii-podkatnoi-dp-2-photo-203e.jpg', 'https://besplatka.ua /aws/746x-/99/05/36/77/domkrat-pnevmaticheskii-podkatnoi-dp-2-photo-aaed.jpg']
- url: https://besplatka.ua/ru/obyavlenie/domkrat-pnevmaticheskii-podkatnoi-dp-2-fb60e9
- City: Cherkasy
- Condition: New
- description: • minimum height : 135 mm • maximum height : 320 mm • max. lifting capacity : 2.5 t. • max. admissible pressure: 6 atm. • own weight: 17 kg With the help of this pneumatic jack, the wheels of cars, minibuses and light trucks can be pulled out without any physical effort. The design allows lifting vehicles with relatively low ground clearance. The height of the jack allows it to be used for lifting almost all cars. The lifting capacity of the jack is determined by the operating pressure in the pneumatic line and ranges from 1 ton (at a pressure of 2 atm.) To 2.5 tons (at a pressure of 6 atm.). estimated loading) with pneumatic jacks in the ratio of one DP-2 to two DP-3. Raising the car: place DP-2 in the required place under the bottom, connect compressed air and open the valve. Having raised the car to the required height, turn off the tap. Lowering the car: disconnect the compressed air, open the tap. To avoid failure of the telescopic stabilizing device located inside the corrugated chamber, the load must be placed strictly in the center of the jack. Maintenance of the product. To increase the service life of the jack it is recommended to unscrew the upper faceplate once every six months and carefully lift it, holding the corrugated chamber in place and clean the parts of the telescopic stabilizer with a clean dry rag and re-lubricate SHRUS4-6. Perform assembly. To avoid failure of the telescopic stabilizing device located inside the corrugated chamber, the load must be placed strictly in the center of the jack. clean the parts of the telescopic stabilizer with a dry rag and re-lubricate SHRUS4-6. Perform assembly. To avoid failure of the telescopic stabilizing device located inside the corrugated chamber, the load must be placed strictly in the center of the jack. clean the parts of the telescopic stabilizer with a dry rag and re-lubricate SHRUS4-6. Perform assembly. holding the corrugated chamber in place and with a clean dry rag, clean the parts of the telescopic stabilizer and re-lubricate SHRUS4-6. Perform assembly. holding the corrugated chamber in place and with a clean dry rag, clean the parts of the telescopic stabilizer and re-lubricate SHRUS4-6. Perform assembly.