Датаком авр-12
Гарантия возврата денег, если товар не подойдёт
Свойства товара
- img: ['https://besplatka.ua/aws/746x-/97/60/40/49/datakom-avr-12-regulyator-naprugi-generatora-zminnogo-strumu-photo-3982.jpg', 'https ://besplatka.ua/aws/746x-/97/60/40/49/datakom-avr-12-regulyator-naprugi-generatora-zminnogo-strumu-photo-80db.jpg', 'https://besplatka. ua/aws/746x-/97/60/40/49/datakom-avr-12-regulyator-naprugi-generatora-zminnogo-strumu-photo-4515.jpg', 'https://besplatka.ua/aws/746x -/97/60/40/49/datakom-avr-12-regulyator-naprugi-generatora-zminnogo-strumu-photo-0167.jpg']
- url: https://besplatka.ua/ru/obyavlenie/datakom-avr-12-regulyator-naprugi-generatora-zminnogo-strumu-6aad5c
- City: Kyiv
- Condition: New
- description: DATAKOM AVR-12 Voltage Regulator - an electronic device that allows the generator to generate a fixed output voltage. Vіn maє vіdkrite shasi, resinous design and appointments for installation in the terminal block of the generator. In principle, the summation is applied to brushless type generators. AVR-12 can have a special electronic circuit without a relay. The block does not avenge ruhomih parts; This is due to the fact that the building has a strong vibration in the mind. The AVR-12 includes a low-frequency sound circuit. A simple wiring diagram allows the attachment to be switched on and off easily. Switching the phase to the neutral of the generator and regulating the voltage of the constant stream, is applied to the winding of the wake-up, to reach the load voltage. The function of protection from low frequencies will be proponated. Scheme of frequency vimiryuvannya constant control of the output of the generator and secures the low-frequency sound of the alarm system, changing the output voltage in proportion to the frequency below 45 Hz. FUNCTION: Half-wave thyristor output, 0-10 amperes. Vikhid Strum, Vikhіdna Podruug 0-115 V, relay scheme, low-frequency Zachist, the regulatory of the corns, regaluvannia of the stabil, the function of the distance of the pile, the simplest scheme of the generators: the same-phase. less than 195-265 VoltFrequency: 50/60 Hz. Frequency protection Range: 40-50 Hz Output voltage: 0-115 volts constant jet at 230 volts +/- 2% beep. Internal melting point: 10A (Swedish code) Operating temperature: outside -10C (14F) to 60C (140F). Storage temperature: outside -20C (-4F) to 80C ( 176F). Maximum water content: 95% non-condensing. Dimensions: 125x68x35 mm (L x W x H) Creeper: 115 mm, 2xM6 Bar: 200 grams. Turn the Stabilization potentiometer up to the end of the year arrow.2. Starting the generator without navantazhennya3. Turn the Stabilization potentiometer in the right direction until the moment when the generator voltage ceases to be stable and begins to sway.4. Turn the potentiometer troch by the arrow of the year in order to turn into the zone of stability, but not too far in front of the cordon of the cob of the zone of instability. This will be the optimal tuning point for this generator. o -10C (14F) to 60C (140F). Storage temperature: o. -20C (-4F) to 80C (176F). condensation. Dimensions: 125x68x35 mm (L x W x H) Creepers: 115 mm, 2xM6Ware: 200 grams. Short fitting instructions: 1. Turn the Stabilization potentiometer up to the end of the year arrow.2. Starting the generator without navantazhennya3. Turn the Stabilization potentiometer in the right direction until the moment when the generator voltage ceases to be stable and begins to sway.4. Turn the potentiometer troch by the arrow of the year in order to turn into the zone of stability, but not too far in front of the cordon of the cob of the zone of instability. This will be the optimal tuning point for this generator. o -10C (14F) to 60C (140F). Storage temperature: o. -20C (-4F) to 80C (176F). condensation. Dimensions: 125x68x35 mm (L x W x H) Creepers: 115 mm, 2xM6Ware: 200 grams. Short fitting instructions: 1. Turn the Stabilization potentiometer up to the end of the year arrow.2. Starting the generator without navantazhennya3. Turn the Stabilization potentiometer in the right direction until the moment when the generator voltage ceases to be stable and begins to sway.4. Turn the potentiometer troch by the arrow of the year in order to turn into the zone of stability, but not too far in front of the cordon of the cob of the zone of instability. This will be the optimal tuning point for this generator. 95% non-condensing. Size: 125x68x35 mm (L x W x H) Creeper: 115 mm, 2xM6 Bar: 200 grams. Turn the Stabilization potentiometer up to the end of the year arrow.2. Starting the generator without navantazhennya3. Turn the Stabilization potentiometer in the right direction until the moment when the generator voltage ceases to be stable and begins to sway.4. Turn the potentiometer troch by the arrow of the year in order to turn into the zone of stability, but not too far in front of the cordon of the cob of the zone of instability. This will be the optimal tuning point for this generator. 95% non-condensing. Size: 125x68x35 mm (L x W x H) Creeper: 115 mm, 2xM6 Bar: 200 grams. Turn the Stabilization potentiometer up to the end of the year arrow.2. Starting the generator without navantazhennya3. Turn the Stabilization potentiometer in the right direction until the moment when the generator voltage ceases to be stable and begins to sway.4. Turn the potentiometer troch by the arrow of the year in order to turn into the zone of stability, but not too far in front of the cordon of the cob of the zone of instability. This will be the optimal tuning point for this generator. Turn the Stabilization potentiometer in the right direction until the moment when the generator voltage ceases to be stable and begins to sway.4. Turn the potentiometer troch by the arrow of the year in order to turn into the zone of stability, but not too far in front of the cordon of the cob of the zone of instability. This will be the optimal tuning point for this generator. Turn the Stabilization potentiometer in the right direction until the moment when the generator voltage ceases to be stable and begins to sway.4. Turn the potentiometer troch by the arrow of the year in order to turn into the zone of stability, but not too far in front of the cordon of the cob of the zone of instability. This will be the optimal tuning point for this generator.