Шнековый экструдер кэш-2 (380 в)
Гарантия возврата денег, если товар не подойдёт
Свойства товара
- img: ['https://images.ua.prom.st/149822625_kormoekstruder-shnekovyj-kesh-2.jpg', 'https://images.ua.prom.st/149822628_kormoekstruder-shnekovyj-kesh-2.jpg' , 'https://images.ua.prom.st/149822629_kormoekstruder-shnekovyj-kesh-2.jpg']
- url: https://besplatka.ua/ru/obyavlenie/kormoekstruder-shnekovyi-kesh-2--380-v-e7d792
- City: Lviv
- description: The feed extruder is used to produce exploded grain. It is used in feed shops of poultry and livestock farms. The device consists of an electric motor, starting equipment, a dosing mechanism and an extruder part connected with an electric motor by means of a clamping gear. The extruder part consists of a loading hopper, a loading chamber, a pressing chamber. A system of screws is located in these chambers - feeding, intermediate and pressing. The pressing chamber ends with a die, in which maximum compression occurs and through which the extruded product exits. The extruded product exits through the die in a continuous stream in the form of a tube with a diameter of about 22 mm. cattle and poultry. During the operation of the device, a number of changes occur in the grains: fiber conversion; dry gelatinization of starch; under the influence of high pressure (20-30 atm) and temperature (130-160 gr.), Dangerous microflora (bacteria, mold, fungi) dies. any flat surface. The installation does not require a foundation. There are no external heaters in the device. In 1 minute after the start of the extrusion process, you begin to receive a finished high-quality product. The supplied grain does not need to be pre-steamed. The feed extruder consists of: an electric motor connected by a V-belt to the extruder part. The extruder part consists of a feed hopper, a bearing assembly with two bearings, a tray, loading neck with a watering can, tray movement mechanism, pressing chamber, loading chamber. Feeding, intermediate and pressing screws are installed on the shaft. Pressing rings are installed between them. A pressing cone is located at the end of the shaft. A mechanism for moving the tray and a pulley is installed on the shaft from the drive side. 3.7 Current consumption, A: with a 3-phase network: 5.6 Current consumption, A: with a 1-phase network: 15 Overall dimensions, h\w\d: 125\40\48 cm. Weight, kg: 83 Availability: In stock